Page 44 - Occupational Health & Safety, February 2017

HAND PROTECTION
How to Choose Gloves to Protect Against Arc Flash
You don’t want to wear gloves that will burn, catch fire or not protect from heat. Beyond sustained injuries, ignoring the need for proper electrical PPE can result in huge fines. BY AMANDA GREEN
There are a lot of misconceptions about arc flash, starting with what it actually is. It is not a flash of light or an arc of fire. It is related to but not the same as electric shock, and there is not usually direct contact with electricity. Yet arc flash is deadly serious, and there are more than 30,000 inci- dents that result in 400 fatalities every year. So how can you protect your hands from this deadly killer?
Can Arc Flash Be Prevented?
Yes. Let’s start by exploring what arc flash is. Arc flash is an electrical current that jumps from the desired path and travels through the air from one conductor to another. It incorporates both radiant and convec- tive heat and can reach temperatures of up to 35,000° F. Imagine a bolt of lightning veering off course. It has the potential to ignite clothing and burn workers. Anyone in the path of the electrical discharge or in the vicinity can be severely injured or even killed.
Arc flashes can occur around high-voltage or cur- rent machinery for several different reasons, including:
■ Incorrect wire gauge
■ System overload
■ Worn-through or thinning insulation
■ Corroded contacts
■ Cleaning with flammables
■ Dropped, misplaced, or improperly used tools
■ Accidental human contact due to inappropri-
ate gloves or other PPE
■ Improper or incomplete installation of equipment The most obvious and best way to prevent an arc
flash is to work on de-energized equipment. If there is no current flowing through a device, there will be no arc flash. Sometimes, however, it is necessary to work on energized equipment or on equipment whose sta- tus is unknown. In these circumstances, it is important to work with your safety specialist to find the proper hand protection for working with energized circuits.
1. Prevent ignition by wearing gloves that will not ignite.
While arc flash injuries can be to the face, hand, or body, hands are normally first to catch fire. Therefore you don’t want to wear gloves that will burn, catch fire, or not protect from heat. Beyond sustained injuries, ignoring the need for proper electrical PPE can result in huge fines.
Rubber insulating gloves are traditional for work- ing with arc flash hazards. Rubber insulating gloves can be bulky or difficult to work in, so lighter-weight arc flash and electrical gloves are coming into the market.
When do you need to wear rubber-insulating gloves, and when can you simply wear arc flash- rated gloves without rubber-insulating gloves un- derneath? According to the NFPA 70E and the CSA Z472 standards, all types of work with shock expo- sures of greater than 50V require the use of rubber insulating gloves.
Most non-rubber arc flash gloves are either leather or coated, and they are all FR protective. The materi- als they are made from can be either inherently FR (like aramid, leather, wool, glass, and coated nylon) or treated (as in with Pyrovatix, Proban, or Indura).
2. Wear gloves with sufficient protection.
Protection must be adequate for the specific threat (level of exposure) presented by the equipment that you are working with. The arc rating of the machinery you are working on should be written on the electri- cal panel. If it isn’t, check the manufacturer’s specifi- cations. To choose the best glove for a job, you need to understand Hazard Risk Category (HRC) and Arc
40 Occupational Health & Safety | FEBRUARY 2017
www.ohsonline.com
WEST CHESTER PROTECTIVE GEAR